7. EQUIPMENT CONFIGURATION (INSTALLATION
WIZARD)
7.1 INTRODUCTION
The Installation Wizard appears on the screen in the following cases:
▪ At the rst switching on of equipment, during the installation phase;
For details about the installation requirements, see the document Technogym Bike Live
Pre-Installation requirements, available on Technogym Direct.
▪ After a recovery procedure;
▪ After a console replacement.
If you update the SW of congured equipment, the installation wizard doesn’t appear on the screen
since the UNITY display is already congured.
7.2 INSTALLATION WIZARD
1. Switch on the equipment.
2. Select the desidered language.
Fig. 44
TECHNOGYM BIKE LIVE Technical Service Guide
Rev. 2.0
- 57 -TSG-00187-EN - Uncontrolled copy if printed
To Next Page
Loading...
