To adjust the play for the handlebar vertical slider:
- unscrew the screw (E) and remove the cover (F);
- unscrew the screw (G) and remove the lever (H);
- adjust the ring nut (K);
- check the play of the handlebar along the entire length;
- rassemble the lever (H) and the cover (F).
If the screws (C) and (D) or the ring nut (K) are tightened (to the right), sliding becomes harder.
If the screws (C) and (D) or the ring nut (K) are loosened (to the left), sliding becomes easier.
Turn the nut 1/8 of a turn at a time and check the sliding before proceeding.
TECHNOGYM BIKE LIVE Technical Service Guide
Rev. 2.0
- 92 - TSG-00187-EN - Uncontrolled copy if printed
To Next Page
Loading...
