RUN XT: Service & Maintenance Manual - rev. 2.0
Page 9.2
and press ENTER to confirm your choice.
9.1.3. MAXIMUM TIME
You can set the maximum time that can be programmed for each exercise. To change the current
setting, when the maximum time is actually in use will scroll on the LED matrix, input the desired
time using the numeric keys and press ENTER to confirm.
9.1.4. ACTIVATING THE “+” AND “−−” KEYS
The user can enable the “+” and “−” keys to modify the target heart rate during exercise sessions in
CPR mode. To change the current setting, when the setting is actually in use will scroll on the LED
matrix, press the proper numeric key (1 or 2) to choose the desired setting, as for the following
table:
number key
“+” and “−” keys
1 OFF = DISABLED
2 ON = ENABLED
and press ENTER to confirm your choice.
9.1.5. DISABLING THE FUNCTION KEYS
The function keys can be disabled so that exercise sessions can be started only using the TGS
portable memory. To change the current setting, when the setting is actually in use will scroll on the
LED matrix, press the proper numeric key (1 or 2) to choose the desired setting, as for the following
table:
number key function keys
1 OFF = DISABLED
2 ON = ENABLED
and press ENTER to confirm your choice.
9.1.6. ENABLING THE “ENTER” KEY
The “ENTER” key can be enabled to increase the amount of exercising time during manual and CPR
training sessions. To change the current setting, when the setting is actually in use will scroll on the
LED matrix, press the proper numeric key (1 or 2) to choose the desired setting, as for the following
table:
number key “Enter” keys
1 OFF = DISABLED
2 ON = ENABLED
and press ENTER to confirm your choice.
The system will now go back to the standby mode. The “CLEAR” key can be pressed at any time to
interrupt the setup procedure and return the equipment to the standby mode.
To Next Page
Loading...
