Technogym Run XT - Disassembling the Up-Down Motor

RUN XT: Service & Maintenance Manual - rev. 2.0
Page 7.22
7.15. DISASSEMBLING THE UP-DOWN MOTOR
Figure 7.15-1
1. Carry out the procedure described in
paragraph 7.14. “Disassembling the up-down
motor belt” up to the slackening of the belt
(step 7).
2. Disconnect the motor power supply cable and
the photocell cable.
3. If present, use a 10-mm wrench to remove
the 2 fixing screws from the cover of the
protective housing of encoder wheel a
4. Open the cover.
5. Use a 10-mm wrench to remove screw b.
6. Disassemble encoder wheel a.
Figure 7.15-2
7. Remove the spacer c.
Continued on the following page →