Technogym Run XT - Display Shows E3 or E4

RUN XT: Service & Maintenance Manual - rev. 2.0
Page 6.8
6.3. THE DISPLAY SHOWS “E3” OR “E4”
These messages are related to the belt motor group. The machine displays:
• E3 failure to actuate movement of the belt motor at the start of the training session;
• E4 the movement of the belt motor is interrupted during the training session.
THE DISPLAY
SHOWS "E3" OR
"E4"
Check the error message
displayed and/or
memorized by the inverter
E1
E2
E3
E4
E5
E6
E7
E8
E9
E10
E11
E12
E14
None
The paragraphs below illustrate the troubleshooting procedures for each individual error code.