RUN XT: Service & Maintenance Manual - rev. 2.0
Page 7.5
7.5. DISASSEMBLING THE CARDIO RECEIVER
Version A: receiver positioned under the display.
Figure 7.5-1
1. Place the machine in its maximum elevation
position.
2. Turn off the machine and unplug the mains
lead from the wall outlet.
3. Cut strap a.
Figure 7.5-2
4. Lift the lexan instruction panel b, and open
the box c which houses the RECEIVER.
5. Disconnect connector d of cable BK-7 from
the RECEIVER.
6. Remove the RECEIVER.
To reassemble the RECEIVER, carry out the
above steps in reverse order, positioning it
between the 2 foam pads and using a new strap
to secure the box.
To Next Page
Loading...
