Technogym Run XT - Disassembling the Running Track

RUN XT: Service & Maintenance Manual - rev. 2.0
Page 7.12
7.9. DISASSEMBLING THE RUNNING TRACK
Figure 7.9-1
1. Turn off the machine and unplug the mains
lead from the wall outlet.
2. Unscrew the 2 screws a using a 6-mm Allen
T wrench.
3. Remove the rear caps b on the right and left
hand sides.
4. Unscrew the 2 screws c fixing the footrests
using a 5-mm Allen T wrench.
Figure 7.9-2
5. Remove the footrests by pulling them toward
the back of the machine.
Continued on the following page→