Technogym Selection M810 - The Weight Stack Cable Is Not Taut; Adjusting the Tension of the Cable with Crimped Fitting

SELECTION LINE: Service & Maintenance Manual - rev. 4.0
Page 5.2
5.2. THE WEIGHT STACK CABLE IS NOT TAUT
This problem is due to lengthening of the weight stack cable. Therefore, to solve the problem you
must use the cable tension adjustment system.
If the cable is new, before adjusting its tension, it is necessary to do a few reps at
maximum load to “stretch” the cable itself.
There are 2 possible mechanical solutions:
 weight stack with crimped cable;
 weight stack with doubling pulley.
the 2 different adjustment procedures detailed here below correspond to these two mechanical
options:
5.2.1. ADJUSTING THE TENSION OF THE CABLE WITH
CRIMPED FITTING
This operation applies to Abdominal Crunch, Abductor, Adductor, Easy Chin Dip,
Glute, Leg Curl, Leg Extension, Lower Back, Rotary Calf and Total Abdominal.