SELECTION LINE: Service & Maintenance Manual - rev. 4.0
Page 5.32
5.17. IT’S DIFFICULT TO ROTATE THE BARBELL ON THE
MULTIPOWER
To eliminate the difficulty of rotating the barbell on the Multipower machine, the sleeve has been
modified as follows:
The modification involves the use of bearings in place of the bronze bushings.
The modification, taken in its entirety, is interchangeable with the old solution. The order codes of
the sleeves are:
Where the * character must be replaced by GG for Selection Classic or by GD for Personal
Selection, followed by the desired color variant.
NOTE: the above codes do not include the cables shown in the drawing.
The first machine produced that incorporates this modification has SN M853 05000010.
To Next Page
Loading...
