SYNCHRO EXCITE 2009: Service & maintenance manual - rev. 5.2
Page 7.33
Figure 7.12-4
3. Remove the screw (d) that is locking the bar
(e) with a medium extractor, as shown in the
figure at the side.
Figure 7.12-5
Carry out the operations described in
paragraph: 7.7.3. “Front guard”.
4. Remove the plug (f) using a small flat Phillip
screwdriver, on both the sides.
Figure 7.12-6
5. Back off the nut (g) using a 17mm wrench,
locking the bolt on the opposite side with the
same wrench, as shown in the figure.
ATTENTION: During reassembly lock
down the nut using a torque wrench
setting of 40Nm.
Continued in following page
→
To Next Page