TECO JSDG2S Series - 5-6-4 Brake Mode

5-131
5-6-4 Brake Mode
The user can customize the brake combination when Servo off, EMC and CCW/CW drive
prohibition. The setting is as follows:
Cn008.0 Brake Mode
Initial Value Unit Setting Range Effective RS-485 Address
2 -- 0 ~ 5 Effective after Confirm Key 0009H
Setting Description: The Brake Combination of Servo off, Emergency Stop (EMC), and when
CCW/CW Drive is Prohibited.
Setting
Description
Dynamic Brake Mechanical Brake
0 No No
1 No Yes
2 Yes No
3 Yes Yes
4 No (under 100rpm) No
5 No (under 100rpm) Yes
Attention
When CCW/CW generates drive prohibition, the setting of if use dynamic brake Cn009.0 is
prior to Cn008, i.e. if Cn008.0 is set as 0 or 1 (without dynamic brake) and Cn009.0 is set as 1
(with dynamic brake), the dynamic brake will be implemented eventually.
Cn008.1 Forced action of mechanical brake
Initial Value Unit Setting Range Effective RS-485 Address
0 -- 0 ~ 1 Effective after Confirm Key 0009H
Setting Description: Mechanical brake is forced action.
Note: If the relevant parameters of the mechanical brake are not set, the forced action function is
invalid.
Setting Description
0 Forced action of mechanical brake disable
1 Forced action of mechanical brake enable