TECO JSDG2S Series - Motor with Mechanical BRAKE Wiring Instructions

2-15
TB terminal maximum screw locking strength table
Servo Model Number
Maximum screw locking strength (kgf-cm / in-lbs)
Control Circuit
Terminals
Primary Circuit Other
Terminals
JSDG2S - 10A / 15A / 20A / 30A ------ (Pluggable Terminal)
JSDG2S - 50A3 / 75A3
JSDG2S - 10B/15B/25B/35B
------ (Pluggable Terminal)
JSDG2S -100A3 / 150A3
JSDG2S - 50B/75B
16 / 13.9
JSDG2S - 200A3
JSDG2S - 100B
18 / 15.6 30 / 26
JSDG2S - 300A3
JSDG2S - 150B/200B
15 / 13 30 / 26
2-1-6 Motor with Mechanical BRAKE Wiring Instructions
If you wish to disable the mechanical brake, please connect the thin white wire of JSMA small
motor series to DC +24V
(no polarity difference)
. For JSMA medium and large capacity series, the
output is from “
A” & “F” pins of motor power connector
and must be disabled to make the servo
motor operate normally.