3-2
3-1 Driver Panel Operating Instructions
3-1-1 The Name and function of the Panel
This Device contains five LED seven-segment displays, four operating keys and a
CHARGE
Indicator
, as shown in the following Figure.
When CHARGE indicator (red)
is on, it means power
still exists in the primary circuit of the device when the power is switched off. Users must disconnect
the cables until this indicator completely goes out.
Key Symbol Key Name Key Function Description
Mode Selection
Key
(MODE Key)
1. Select from 12 parameters offered by this device. The
parameter will rotate by each press.
2. When setting the data screen, click to jump back to the
parameter selection screen.
Number Up Key
(UP Key)
1. Select each parameter item.
2. Change the number data.
3. Press the and keys at the same time to clear the
Error Alarm State.
Down Key
(DOWN Key)
Data Setting Key
(ENTER) Key
1. Data Confirmation; Parameter Item Confirmation.
2. Move left to adjust the number of digits.
3. End the setting data.
5-digit LED
7-segment display
4 operation keys
LED light
To Next Page
Loading...
