TECO JSDG2S Series - Panel Operating Example

3-6
3-1-5 Panel Operating Example
The following provides a setting example. All key functions are used. Users can operate once to
understand the function of each key, for example, to set
Sn203
(Internal Speed Command 3) to
100rpm, please follow the steps below:
Steps
Operation
Key
LED Display Screen
after Operation
Description
1
Turn on
Power
When the power is turned on, Enter the
Status
Display Screen
.
2
Press MODE Key 6 times to enter
Speed Control
Parameters
.
3
Press UP Key 2 times to select the
Speed Control
Parameter
Items.
4
After press and hold the ENTER Key for 2 seconds to
enter
Sn203
Setting Screen,
5
Press ENTER Key 1 time, move left to adjust the
number of digits (flashing LED).
6
Press ENTER Key 1 time, move left to adjust the
number of digits (flashing LED).
7
Press DOWN Key 2 times, to adjust the hundredths
digit number 3 downwards to 1.
8
Press and hold the ENTER Key for 2 seconds until -
SET- appears, indicating the current set value has been
saved and after the -SET- appears once, jumps back to
the current parameter item selection screen
immediately.
When entering the setting screen and don't want to make any setting adjustments, simply press
the MODE Key once to jump back to the Parameter Selection Screen.
Steps
Operation
Key
LED Display Screen
after Operation
Description
1
Turn on
Power
When the power is turned on, Enter the
Status
Display Screen
.
2
Press MODE Key 6 times to enter
Speed Control
Parameters
.
3
Press UP Key 2 times to select the
Speed Control
Parameter
Items.
4
After press and hold the ENTER Key for 2 seconds to
enter
Sn203
Setting Screen,
5
Press MODE Key 1 time to jump back to the
Parameter Selection Screen.