TECO JSDG2S Series - TB Terminal Description

2-14
2-1-5 TB Terminal Description
Name
Terminal
Symbol
Detailed Description
Control Circuit Power
Input terminal
r
200V

Connect External AC Power.

Single-phase 200~230VAC +10 ~ -15% 50/60Hz ±5%
s
24V
400V

Connect external DC power.

Single-phase 24VDC ±10%
0V
Primary Circuit Power
Input terminal
R
200V

Connect External AC Power.

Single / Three Phase 200~230VAC +10 ~ -15% 50/60Hz
±5%
400V

Connect External AC Power.

Three Phase 380~480VAC ±10% 50/60Hz ±5%
S
T
External Regenerative
Resistor Terminal
P
When using the external regenerative resistor, the capacity can
be increased according to requirement. Please refer to
Cn012
resistance to set up.

When external regenerative resistor is not used, PC-P1
must be shorted and do not connect any wire to P.

When using external regenerative resistor, please add
the regenerative resistor between PC-P and do not
connect any wire to P1.
Regenerative Terminal
Common Point
PC
Internal Regenerative
Resistor Terminal
P1
Motor Power Output
Terminal
U
Output to motor U phase power, motor terminal wire color is
red
.
V
Output to motor V phase power, motor terminal wire color is
white
.
W
Output to motor W phase power, motor terminal wire color is
black
.
Motor casing
grounding terminal
FG
The motor casing ground wire contact, motor terminal wire
color is
green
or
yellow-green
.