3-8
Steps
Operation
Key
LED Display Screen
after Operation
Description
the current parameter item selection screen
immediately.
(3) If the settable range is more than 5 digits, for example, set
Pn402
(Internal Position Command 1-
Number of Pulses)=0 to -100000.
Steps
Operation
Key
LED Display Screen
after Operation
Description
1
Turn on
Power
When the power is turned on, Enter the
Status
Display Screen
.
2
Press MODE Key 8 times to enter the
Point to Point
Position Control Parameters
.
3
Press UP Key 1 time, to select the Item of
Control
Parameter Item for Multi-position Control
.
4
Press and hold the ENTER Key for 2 seconds, to enter
the
Pn402
Setting Screen.
5
Press ENTER Key 5 times, to move the adjustable
digits 5 places to the left.
6
Press DOWN Key 1 time, to adjust the 10,000th digit
down to 1, and the decimal point of all digits is ON,
indicating that the current setting value is negative.
7
Press and hold the ENTER Key for 2 seconds until -
SET- appears, indicating the current set value has been
saved and after the -SET- appears once, jumps back to
the current parameter item selection screen
immediately.
To Next Page
Loading...
