-
----,
2230 Operators
OPERA TORS SAFETY SUMMARY
The
general safety information
in
this
part
of
the summary is for both operating and servicing personnel.
Specific warnings and cautions will be found throughout the manual where they apply and do not appear
in
this
summary.
Terms
in
This Manual
CAUTION statements identify conditions or practices that
could result
in
damage to the equipment or other property.
WARNING statements identify conditions or practices that
could result
in
personal injury or loss of life.
Terms as Marked
on
Equipment
CAUTION indicates a personal injury hazard not immedi-
ately accessible
as
one reads the markings, or a hazard to
property, including the equipment itself.
DANGER indicates a personal injury hazard immediately
accessible
as
one reads the marking.
Symbols
in
This Manual
This symbol indicates where applicable cau-
tionary or other information
is
to
be
found. For
maximum input voltage
see
Table
1-1
.
Symbols as Marked
on
Equipment
~
DANGER - High voltage.
@ Protective gound (earth) terminal.
,& ATTENTION - Refer to manual.
Power Source
This product
is
intended to operate from a power source
that does not apply more than 250 volts rms between the
supply conductors or between either supply conductor
and
ground. A protective ground connection
by
way of the
grounding conductor
in
the power cord
is
essential for safe
operation.
Grounding the Product
This product
is
grounded through the grounding conductor
of the power cord. To avoid electrical shock, plug the
power cord into a properly wired receptacle before con-
necting to the product input or output terminals. A protec-
tive ground connection
by
way of the grounding conductor
in
the power cord
is
essential for safe operation.
Danger Arising from Loss of Ground
Upon loss of the protective-ground connection,
all
accessi-
ble conductive parts (including knobs
and
controls that
may appear to
be
insulating)
can
render
an
electric shock.
Use the Proper Power Cord
Use only the power cord
and
connector specified for your
product.
Use only a power cord that
is
in
good condition.
For detailed information
on
power cords
and
connectors,
see Figure 2-2.
Use the Proper Fuse
To avoid fire hazard, use only a fuse of the correct type,
voltage rating
and
current rating
as
specified
in
the parts
list for your product.
Do
Not Operate
in
Explosive Atmospheres
To avoid explosion, do not operate this product
in
an
explosive atmosphere unless it has
been
specifically
certified for such operation.
Do Not Remove Covers or Panels
To avoid personal injury, do not remove the product cov-
ers or panels.
Do
not operate the product without the cov-
ers
and
panels properly installed.
vii
To Next Page
Loading...
Need help?
General
