Tektronix 2230 Operator's Manual

General lnformation-2230 Operators
Table 1-1 (cont)
Characteristics Performance Requirements
HORIZONTAL DEFLECTION SYSTEM
NON STORE Sweep Rates
Calibrated Range
A Sweep 0.5 sec per division to 0.05 µs per division in a 1-2-5 sequence of
22 steps.b
B Sweep 50 ms per division to 0.05 µs per division in a 1-2-5 sequence of
19 steps.b
STORE Mode Ranges
REPETITIVE
0.05 µs per division to 2 µs per division.c
RECORD 5 µs per division to 50 ms per division.c
ROLL/SCAN 0.1 s per division to 5 s per division (A sweep only).c
NON STORE Accuracy
Unmagnified Magnified
+15°C to +35°C
0.5 s/div to 0.1 µs/div
Within ±2%
Within ±3%
0.05 µs/div
Within ±2%
Within ±4%
0°c to +50°C
0.5 s/div to 0.1 µs/div
Within ±3%
Within ±4%
0.05 µS/div
Within ±3% Within ±6%
Sweep accuracy applies over the center eight divisions. Exclude
the first 40 ns of the sweep for magnified sweeps and anything
beyond the 100th magnified division.
STORE Accuracy
See Horizontal Differential Accuracy and Cursor Time Difference
Accuracy.
NON STORE Sweep Linearity
0.5 s/div to 10 ns/div
Within ± 0.1 division.
5 ns/div
Within ± 0.15 division.
Linearity measured over any two of the center eight divisions.
Exclude the first 40 ns and anything past the 100th division of the
X10 magnified sweeps.
Digital Sample Rate Single Trace
CHOP/ALT
SAMPLE
100 50
(5 µs/div to 5 s/div)
Hz Hz
SEC/DIV SEC/DIV
PEAKDET or ACCPEAK
10 MHz 10 MHz
(20 µs/div to 5 s/div) (50% duty factor on each channel in CHOP)
REPETITIVE Store
0.05 µS/div to 1 µS/div 20 MHz 20 MHz
2 µS/div 10 MHz 10 MHz.
bThe X10 MAG control extends the maximum sweep speed to 5 ns per division.
cThe X10 MAG control extends the maximum sweep speed to 5 ns per division. The 4K COMPRESS control multiplies the SEC/DIV
by 4.
1-8
- -

Tektronix 2230 Specifications

General

Brand	Tektronix
Model	2230
Category	Test Equipment
Language	English