Tektronix 2230 Operator's Manual

2230 Operators
TABLE OF CONTENTS (cont)
Page
Section 7 OPTIONS AND ACCESSORIES
INTRODUCTION....................................... 7-1
GENERAL INFORMATION....................... 7-1
STANDARD ACCESSORIES............... 7-1
OPTIONAL ACCESSORIES................. 7-1
INTERNATIONAL POWER CORD
OPTIONS.............................................. 7-2
OPTION 10 ........................................... 7-2
OPTION 12 ........................................... 7-2
OPTION 33 ........................................... 7-2
COMMUNICATIONS OPTION
OPERATION.............................................. 7-2
ADVANCED FUNCTION MENU
(for the 2230 only) . . .. .. .. . .. .. .. .. .. ... .. . . . . .. .. 7-3
NON-VOLATILE EXTENDED
MEMORY (for the 2230 only)............... 7-3
OPTION 10 GPIB OPERATORS
INFORMATION..................................... 7-3
OPTION 12 RS-232-C OPERATORS
INFORMATION ..................................... 7-10
RS-232-C PROGRAMMING ................. 7-15
COMMUNICATION AND WAVEFORM
TRANSFER ................................................ 7-17
READOUT/MESSAGE COMMAND
CHARACTER SET ............................... 7-17
MESSAGES AND COMMUNICATION
PROTOCOL .......................................... 7-17
WAVEFORM TRANSFERS .................. 7-21
COMMUNICATION COMMANDS ........ 7-24
STATUS BYTES AND EVENT
CODES ................................................. 7-47
2221 SPECIFIC COMMANDS ............. 7-51
Appendix A PERFORMANCE CHECK PROCEDURE
ii
INTRODUCTION ....................................... A-1
PURPOSE............................................. A-1
PERFORMANCE CHECK INTERVAL.. A-1
STRUCTURE........................................ A-1
Page
TEST EQUIPMENT REQUIRED.......... A-1
LIMITS AND TOLERANCES ................ A-1
PREPARATION FOR CHECKS ........... A-1
INDEX TO PERFORMANCE
CHECK STEPS..................................... A-3
VERTICAL................................................. A-4
INITIAL CONTROL SETTINGS............ A-4
PROCEDURE STEPS.......................... A-4
HORIZONTAL. ........................................... A-11
INITIAL CONTROL SETTINGS ............ A-11
PROCEDURE STEPS .......................... A-11
TRIGGER ................................................... A-15
INITIAL CONTROL SETTINGS ............ A-15
PROCEDURE STEPS .......................... A-15
EXTERNAL Z-AXIS, PROBE
ADJUST, EXTERNAL CLOCK,
AND X-Y PLOTTER .................................. A-18
INITIAL CONTROL SETTINGS ............ A-18
PROCEDURE STEPS .......................... A-18
Appendix B
RS-232-C DEVICE
INTERCONNECTION ................................ B-1
INTRODUCTION................................... B-1
DETERMINING DEVICE TYPE............ B-1
INTERCONNECTION RULES.............. B-2
INTERCONNECTION CABLE TYPE
IDENTIFICATION.................................. B-3
RS-232-C INTERCONNECTION
CABLE-TYPE ILLUSTRATIONS.......... B-3
INTERCONNECTION CABLE
PART NUMBERS................................. B-7
PRINTER/PLOTTER OPERATION ........... B-10
PLOTTER TYPES ................................. B-10
QUESTIONS AND ANSWERS ................. B-17
CHANGE INFORMATION

Tektronix 2230 Specifications

General

Brand	Tektronix
Model	2230
Category	Test Equipment
Language	English