Oscilloscope Reference Select the mask autoset mode
Select the mask autoset mode
From the Mask menu, highlight Mask Configure; then select Autoset. From the Mask Testing control
window, click the Autoset Config button.
Overview
Use these co
ntrols to select whether autoset will be done automatically or manually.
To use
Click Au
to to have autoset done automatically after a standard mask is selected.
Click Manual to make adjustments manually.
Behavior
If Aut
o is selected, an autoset is done automatically after a standard mask is selec t ed. The purpose of the
manual autoset mode is to adjust everything that can be done without having any waveform data.
What
do you want to do next?
Learn about trigger level autoset. (see page 855)
Learn about vertical autos et. (see page 856)
Learn about horizontal autoset. (see page 853)
Learn about autofit for autoset. (see page 852)
854 DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series
To Next Page
Loading...
Need help?
General
