Teletek electronics IRIS - Sounder Delay; Fire Output Delay; Fire Protection Delay

Fire Panel IRIS - Installation Manual 35
4.5.1 Sounder Delay
Choose “Sounder Delay” button from “Output Delay” Menu – Fig. Screen 22 to enter the submenu for
sounder delay introduction – Fig. Screen 23.
A delay can be added before the sounders are turned on. This provides the possibility of checking the au
-
thenticity of the alarm before the sounders are turned on (an official visits the site of the fire and inspects for
such).
The delay can be: ON, OFF or Schedule – Fig. Screen 21. In Schedule mode the initial hour and minutes (the
time when the delay is activated) and the end hour and minutes (the time when the delay is deactivated) are
introduced. The times are set for every day of the week. During turned on “Delay” the LED is active.
Fig. Screen 23.
4.5.2 Fire output Delay
Choose “Fire Br. Delay” button from “Output Delay” Menu – Fig. Screen 22 to enter the submenu for fire
output delay introduction (the screen is the same as those for sounder delay introduction).
A delay can be added before the sounders are turned on (fire output). This provides the possibility of check
-
ing the authenticity of the alarm before the sounders are turned on (an official visits the site of the fire and
inspects for such).
The delay can be: ON, OFF or Schedule. In Schedule mode the initial hour and minutes (the time when the
delay is activated) and the end hour and minutes (the time when the delay is deactivated) are introduced. The
times are set for every day of the week. During turned on “Delay” the LED is active.
4.5.3 Fire Protection Delay
Choose “Fire Pr. Delay” button from “Output Delay” Menu – Fig. Screen 22 to enter the submenu for fire
protection delay introduction (the screen is the same as those for sounder delay introduction).
A delay can be added before the fire protection system is turned on. This provides the possibility of check
-
ing the authenticity of the alarm before the sounders are turned on (an official visits the site of the fire and
inspects for such).
The delay can be: ON, OFF or Schedule. In Schedule mode the initial hour and minutes (the time when the
delay is activated) and the end hour and minutes (the time when the delay is deactivated) are introduced. The
times are set for every day of the week. During turned on “Delay” the LED is active.