108
To establish the connection between the alarm control panel and its programming software,
it is necessary to install the Remote Serial Client software. This client software ensures the
connection between the PC and the Adapter2 device, as well as it creates a virtual serial port for
the programming software of the alarm system.
Open the Remote Serial Client software and configure the settings in the order below:
Device ID: enter the device identifier (6x2
hexadecimal characters separated by colons) of
the Adapter2 device connected to the alarm
control panel.
Using the “Read from QR code” button, you can
also read the device ID from the image file saved
from the programming software, that contains
the QR code with the device ID.
Virtual serial port: enter the number of the
virtual port you wish to create (e.g.: COM6).
System logs: shows information about program
operation and displays data received through the
serial port.
Create port: click on this button to create the
configured virtual serial port, then select the
created port in at the serial communication
settings in the programming software of the
alarm system. Please note that the Adapter2
device should be online to create the virtual
serial port.
Example for selecting the serial communication
port in the Bentel Security Suite programming software (see the figure on the right-hand side).
To Next Page
Loading...
