64
4.2.9 IP cameras (Adapter2 PRO only)
In this menu you can configure the availabilities of up to 4 IP cameras with ONVIF support, which
then can be assigned to events in the event settings. If e-mail notifications are configured for
events, the URL of the IP camera assigned to the given events will be sent along with the
messages in the given e-mails when the events occur. If Push notification is configured for an
event, the picture of the IP camera assigned to the given event can be viewed in the mobile
application upon receiving the Push notification.
Available options:
• Reading the settings from the device:
To read the settings from the device, click on the “Read” button. This will read all
settings in all menus.
• Writing the settings into the device:
After changing the settings or entering new settings, to take effect, it is necessary to
write the new settings into the device by clicking on the “Write” button. This will write
the changes only, but all changes made in any menu.
Please note that after you make changes, you must write the settings into the device
to be applied. For this, click on the “Write” button.
To Next Page
Loading...
