tell Adapter2 - Input Events

48
Settings:
Input type: the input can be normally open (NO), or normally closed (NC).
When set to NO, an input event will be generated when the open contact between the given input
(IN1…IN4) and the V- terminal (or the COM terminal) becomes closed.
When set to NC, an input event will be generated when the closed contact between the given input
(IN1…IN4) and the V- terminal (or the COM terminal) becomes open.
Sensitivity / Unit of measure: state changes of the input shorter than the value entered in this
section regarding activation of the input are ignored by the device. The unit of measure can also
be selected (milliseconds, seconds, or minutes). The sensitivity can be configured from
5 milliseconds to 1 hour.
Restore sensitivity / Unit of measure: state changes of the input shorter than the value entered
in this section regarding restoration of the input are ignored by the device. The unit of measure
can also be selected (milliseconds, seconds, or minutes). The sensitivity can be configured from
5 milliseconds to 1 hour.
4.2.6 Input events
In this menu you can configure the events generated by the 4 contact inputs and notifications to
be sent when an input event occurs. Input events should be added and configured for the inputs
you wish to use. If no input event is configured for an input, the given input will not generate events,
nor send notifications. You can add one new and one restore event for each input.