54
Available options:
• Reading the settings from the device:
To read the settings from the device, click on the “Read” button. This will read all
settings in all menus.
• Writing the settings into the device:
After changing the settings or entering new settings, to take effect, it is necessary to
write the new settings into the device by clicking on the “Write” button. This will write
the changes only, but all changes made in any menu.
• Adding a new service event:
To add a new service event, click on the “New” button.
• Creating a copy of an existing service event:
To create a copy of the selected service event, click on the “Clone” button. Please
note that the new copy should have a different unique name.
• Editing service event settings:
To edit the settings of the selected service event, click on the “Edit” button.
• Deleting a service event:
To delete the selected service event, click on the “Delete” button.
Please note that after you make changes, you must write the settings into the device
to be applied. For this, click on the “Write” button.
Event:
Name: custom name of the event. The name entered in this section is used for identification of
the given event within the program and in the event logs. The name should not be longer than
20 characters, and the following characters cannot be used: ^ ~ < > = | $ % " '.
Event: select an event from the available service events in the drop-down menu.
Available service events:
- GSM error: this type of event is generated if the device loses the connection with the GSM
network, or it is unable to register on the GSM network for at least 60 seconds. A restore
event is generated upon successful registration on the GSM network. Most common reasons
for this type of error are the following: there is no SIM card installed in the device, or the card
is not installed properly, the card is damaged, or the service is not available on the SIM card,
low GSM signal, the GSM antenna is not connected, insufficient supply voltage/current.
- Mobile Internet error: this type of event is generated if the device is unable to establish the
Internet connection for at least 60 seconds. A restore event is generated when the Internet
connection restores. Most common reasons for this type of error are the following: wrong
APN configured, or the mobile Internet service is not enabled on the SIM card.
To Next Page
Loading...
