56
- Settings changed: this type of event is generated when the Superadmin user changes
a protected setting, that the Admin user has no access to (which is disabled in the
“Admin access” menu.)
- SMS sending daily limit reached: this type of event is generated when the number of event
SMS messages sent by the device on the given day reaches the value configured at the
“SMS sending daily limit” option in the “General” device settings menu.
- SMS forwarding daily limit reached: this type of event is generated when the number of
incoming SMS messages forwarded by the device on the given day reaches the value
configured at the “SMS forwarding daily limit” option in the “General” device settings menu.
- Daily call limit reached: this type of event is generated when the number of calls initiated
by the device on the given day reaches the value configured at the “Daily limit for calls”
option in the “General” device settings menu.
Type: the type of the event which can be new or restore. A new event will be generated when
a service event occurs, and a restore event will be generated when it restores. In the Contact ID
protocol new event is indicated with 1 (or E), while restore is indicated with 3 (or R).
Remote monitoring:
In this section you can configure the Contact ID event code for reporting to CMS and can select
the preconfigured notification template for the given event. The Contact ID event code should only
be configured if reporting to CMS is used, otherwise select the notification template named
“EMPTY”.
Event code: in this section you can configure the 3-digit Contact ID event code, consisting of
characters 0...9,A,B,C,D,E,F, which you wish to assign to the given event (e.g. 302 = battery fault).
Partition: in this section you can configure the 2-digit partition number which you want to assign
to the given event, from 00 to 99.
Zone: in this section you can configure the 3-digit zone number which you want to assign to the
given event, from 000 to 999.
Notification template: in this section you can select a preconfigured notification template which
you want to use for the given event. If you want to use additional notification templates, these
should be added prior to configuring the events. If you do not want to send a report to CMS on the
given event, select the template named “EMPTY”.
To Next Page
Loading...
