tell Adapter2 - Page 60

60
PWD: the device password can be specified using this parameter. The superadmin and admin
passwords are both accepted (default superadmin password: 1234). The PWD is an optional
parameter which should be used only when sending commands from phone numbers which are
not configured in the device in the Reporting channels menu, in the User phone number
settings section – such phone numbers are considered unauthorized, therefore in this case the
password is required. If the device password is not specified along with the control command sent
from unauthorized phone numbers, the command will not be executed by the device.
Commands sent from unauthorized phone numbers should always begin with a star "" and end
with a hash "#" character.
Example on using custom commands:
The following custom commands will be used in the example: Alert, Open
• When sending from authorized phone numbers:
- Sending one command: Alert or Alert#
- Sending multiple commands: Alert,Open or Alert Open or Alert,Open#
• When sending from unauthorized phone numbers:
- Sending one command: Alert,PWD=1234# or Alert#PWD=1234#
- Sending multiple commands: Alert,Open,PWD=1234# or
Alert#Open#PWD=1234#
Available options in the software:
• Reading the settings from the device:
To read the settings from the device, click on the “Read” button. This will read all
settings in all menus.
• Writing the settings into the device:
After changing the settings or entering new settings, to take effect, it is necessary to
write the new settings into the device by clicking on the “Write” button. This will write
the changes only, but all changes made in any menu.
• Adding a new custom event:
To add a new custom event, click on the “New” button.
• Creating a copy of an existing custom event:
To create a copy of the selected custom event, click on the “Clone” button. Please
note that the new copy should have a different unique name.
• Editing custom event settings:
To edit the settings of the selected custom event, click on the “Edit” button.
• Deleting a custom event:
To delete the selected custom event, click on the “Delete” button.
Please note that after you make changes, you must write the settings into the device
to be applied. For this, click on the “Write” button.