Table 5-69: AWI Event Log Page Parameters
Parameter Description
Event log Messages View: Click to open a browser page that displays the event log
messages (with timestamp information) stored on the device. Press
F5 to refresh the browser page log information.
Clear: Click to delete all event log messages stored on the device.
Event Log Filter Mode Click the pull-down menu to select an event log filtering mode:
l Verbose (default setting)
l Terse
Enable Syslog Enable or disable the syslog standard as the logging mechanism for
the device.
Note: If syslog is enabled, you must configure the remaining fields. If
syslog is disabled, these fields are non-editable.
Identify Syslog Host By Choose if the syslog server host is identified by IP address or by fully
qualified domain name (FQDN).
Syslog Host IPAddress /
Syslog Host DNS name
The parameter that displays depends on which option you choose to
identify the syslog server host:
l IP Address: Enter the IPaddress for the syslog server host.
l FQDN: Enter the DNS name for the syslog server host.
Note: If you enter an invalid IP address or DNS name, a message
appears to prompt you to correct it.
Syslog Host Port Enter port number of the syslog server.
Note: The default port number value is 514.
Syslog Facility The facility is a number attached to every syslog message used to
categorize the source of the syslog messages. The facility is part of
the standard syslog header and can be interpreted by all syslog
servers.
Enter a facility to suit your logging needs. For example, you could
configure devices as follows:
l Zero clients to use facility 19
l Cisco routers to use facility 20
l VMware ESX hosts to use facility 21
Note: The default facility is set to “19 – local use 3”. Cisco routers
default to “23 – local use 7”.
Enhanced logging
mode
To enable enhanced logging mode, select one of the following
categories:
l Audio
l Management Console
l Video
l Networking
l Session Negotiation
TER1206003 Issue 1 249
PCoIP Zero Client and Host Administrator Guide
To Next Page
