Teradici PCoIP Zero TER1206003 - Connecting Hosts and Clients Using the Vmware View Connection Server Broker; Other Configuration Links

4.19.5 Connecting Hosts and Clients Using the VMware View
Connection Server Broker
You can also use the VMware View Connection Server broker to broker a connection
between clients and host cards.
Note: This is not the same thing as configuring a zero client to connect to a VMware View
virtual desktop.
For this option, VMware View Agent must be installed on the host workstation, and a
number of other configuration requirements for both the client and host must be in place. For
complete details, please refer to "Using PCoIP Host Cards with VMware View"
(TER0911004).
4.19.6 Other Configuration Links
To configure the full range of firmware parameters for this session type, see the following
topics.
Note: Some configuration functions are not available in the OSD.
Using the MC Using the AWI Using the OSD
AWI Host: Initial Setup
AWI Client: Initial Setup
MC:Network Settings AWI:Network Settings OSD:Network Settings
For information on how to
manage device naming using
the MC, see the "PCoIP
Management Console User
Manual" (TER0812002).
AWI:Label Settings OSD:Label Settings
MC: Discovery Settings AWI: Discovery Settings OSD: Discovery Settings
MC: SNMP Settings AWI: SNMP Settings
MC: Direct to Host
MC:Direct to Host + SLP Host
Discovery
MC: Connection Management
Interface
AWI Host: Direct from Client
AWI Client: Direct to Host
AWI Client: Direct to Host +
SLP Host Discovery
AWI Host: Connection
Management Interface
AWI Client: Connection
Management Interface
OSD: Direct to Host
OSD: Direct to Host + SLP
Host Discovery
OSD: Connection
Management Interface
MC: Encryption Settings AWI: Encryption Settings
MC: Bandwidth Settings AWI: Bandwidth Settings
MC: Language Settings AWI Client: Language OSD: Language Settings
TER1206003 Issue 1 95
PCoIP Zero Client and Host Administrator Guide