Parameter Description
l 1856x1392 @60 Hz
l 1792x1344 @60 Hz
l 1680x1050 @60 Hz
l 1600x1200 @60 Hz
l 1600x900 @60 Hz
l 1440x900 @60 Hz
l 1400x1050 @60 Hz
l 1366x768 @60 Hz
l 1360x768 @60 Hz
l 1280x1024 @60 Hz
l 1280x960 @60 Hz
l 1280x800 @60 Hz
l 1280x768 @60 Hz
l 1280x720 @60 Hz
l 1024x768 @60 Hz
l 848x480 @60 Hz
l 800x600 @60 Hz
l 640x480 @60 Hz
Any displays attached to the client will be set to the native resolution
of 1024x768 when this option is enabled.
Enable Preferred
Resolution Override
Enable this option when a display is attached but cannot be detected
by the system, and you want to specify a preferred resolution for the
display. The same default list of resolutions as above will be
advertised, except the preferred resolution you configure here for a
display will be sent as the native resolution instead of the default
native resolution of 1024x768.
l Preferred resolution 0: Select the preferred resolution of the
display connected to port 1 on the zero client.
l Preferred resolution 1: Select the preferred resolution of the
display connected to port 2 on the zero client.
l Preferred resolution 2: Select the preferred resolution of the
display connected to port 3 on the zero client.
l Preferred resolution 3: Select the preferred resolution of the
display connected to port 4 on the zero client.
Any displays attached to the client will be set to their specified
preferred resolutions when this option is enabled.
5.27 Configuring Password and Reset Parameters (AWI/OSD)
5.27.1 AWI: Password Settings
The Password page lets you update the local administrative password for the device. You
can access this page for the host or client from the Configuration > Password menu.
The password can be a maximum of 20 characters. Some PCoIP devices have password
protection disabled by default, and the Password page is not available on these devices.
TER1206003 Issue 1 287
PCoIP Zero Client and Host Administrator Guide
To Next Page
