Terumo CDI OneView - Page 137

C-4
Communication with Other Devices
Receiving Data from Pumps and Oximeters
See Chapter 2, “Module Connections” for connecting pumps and oximeters through
Modules and see Chapter 3, “Sensor Connections” for case prole setup.
Caution
 Each type of device will require a separate interface cable
specially congured for that device and the CDI OneView System.
Please see the following section on interfacing tips, or contact
your Terumo Cardiovascular Technical Service Representative for
assistance.
If a pump and/or oximeter is selected in the Sensor Connections Tab, the CDI OneView
System will begin looking for pump ow data and/or oximetry from the Module(s) upon
entering Measurement Mode. If no data is received within a certain time period, the
pop-up Check HLM Interface Module connections or Check RSO
2
Interface Module connections
will appear. The system will reattempt reception of data at regular intervals until the
case prole is changed.
Interfacing TipsInterfacing Tips
Any interface cable used is specic to each device and should be ordered from
Terumo Cardiovascular Customer Administration. These cables will only connect to the
HLM or RSO
2
Interface Modules.
Note: Please consult the operator’s manual of the specic device being used for
instructions on how to properly set up data export through its serial interface.
Supported Pump SystemsSupported Pump Systems
The CDI OneView System supports the following pumping system interfaces:
• Terumo™ Advanced Perfusion System 1
• Terumo™ NEO System
• LivaNova S5/C5®
• Medtronic Bio-Console® 560
Supported Oximeter SystemsSupported Oximeter Systems
The CDI OneView System supports the following oximeters:
• Nonin SenSmart® X-100
• Edwards ForeSight Elite®
• Medtronic INVOS
TM
5100c