Terumo CDI OneView - Page 25

1-21
System Overview
External Data ModulesExternal Data Modules
The CDI OneView System is designed to communicate with
three other types of medical devices: heart-lung machines
(HLMs), regional oximetry devices and data management
system (DMS) equipment. Each module has two connectors,
a serial communication port that links the module to another
medical device and a USB port to connect with the Core.
The system can be congured to acquire blood ow from HLMs. This ow is used
as input in calculation of other parameters, and the ow rate value is displayed. The
system can also be congured to acquire cerebral regional oxygen saturation from a
regional oximetry device, and this value is also displayed. During measurement, data
can be streamed to external data management system (DMS) equipment connected to
an external data module.
Module for HLMModule for HLM
The CDI OneView System can communicate with any of the following HLM devices for
ow rate acquisition:
• Terumo
TM
Advanced Perfusion System 1
• Terumo
TM
NEO System
• Medtronic Bio-Console® 560 Centrifugal Pump
• LivaNova Sorin Stöckert S5/C5®
In addition, the CDI OneView System can send out specic data to Terumo Cardiovascular
HLMs listed below via the external data module:
• Terumo
TM
Advanced Perfusion System 1
• Terumo
TM
NEO System
Module for RSOModule for RSO
22
The CDI OneView System can communicate with any of the regional oximetry devices
listed below for rSO
2
acquisition:
• Nonin SenSmart® X-100
• Edwards ForeSight Elite®
• Medtronic INVOS
TM
5100c
Module for DMSModule for DMS
The CDI OneView System can stream case data records to any DMS equipment that
uses a compatible standard serial communication protocol. The data from the Module
can also be routed via serial hubs into DMS equipment.