4 Transmitter
37
All adjustment processes are saved in the history of the transmitter,
see 7.3.5. Transmitter history.
• Deactivating the adjustment function of the testo 6615
will reduce measuring accuracy and should therefore be
restricted to the shortest possible length of time.
• During the heating phase, the relay and analog outputs,
the display value and output value are "frozen", see
diagram above. Self-adjustment active
display until it has finished. The factory setting for self-
adjustment time (incl. heating time, calculation time,
cooling time) requires 30 minutes daily.
The cycle time
can be edited via the operating menu or the P2A
software.
• In the factory setting, a third adjustment point
(-40 °C
td
) is approached for the testo 6615 in addition to
the 2-point adjustment. This special adjustment can be
performed again by your Testo Service team if
necessary.
To Next Page
Loading...
