TESTO Saveris Series - Initial commissioning of the hardware

6 Commissioning
35
Take into consideration that, if applicable, the testo 184 software
versions have to be installed on different computers, depending on the
application.
5
After completing the installation, restart the computer and log in with
the same user name as before.
Setting up a connection to the AWS bucket in the testo Saveris CFR
software
1
Start the testo Saveris Client software.
In order to be able to connect an AWS bucket, the required permissions
first have to be granted via 21 CFR 11 → Access Control →
Admins.
2
Select System Information -> AWS Settings.
3
Enter the AWS bucket information into the mask.
4
Save the entry.
6.8 Initial commissioning of the hardware
The following preconditions must be fulfilled for the commissioning of the
hardware:

The Saveris base is ready for operation.

All system components (data loggers, probes, etc.) are registered on
the Saveris base.

The Saveris software is installed on the computer.
1
Connect the Saveris base to the computer via the USB cable or
Ethernet.