TESTO Saveris Series User Manual

7 Maintenance
80
7.3 Replacing components
You can shut down a component – Saveris radio data logger, Saveris converter
or Saveris router – at any time, because it is temporarily not being used or, for
example, in order to replace it with a new component in the event of a defect.
If the Saveris base is replaced, a new project must be created. If
necessary, contact our support team.
7.3.1 Deleting components
1
Under Start | All programs | Testo, click on Testo Saveris startup
wizard.

The welcome dialogue for the startup
wizard is displayed.
2
Click on [Next >].

The System status dialogue is
displayed with the General tab.
3
Switch to the Projects tab.

TESTO Saveris Series Specifications

General

Measurement Parameters	Temperature, Humidity, CO2, Pressure, Differential Pressure
Humidity Range	0 to 100 %RH
CO2 Range	0 to 5000 ppm
Communication	Ethernet, WiFi, USB
Data Storage	Internal memory
Alarm	Visual and audible alarms
Power Supply	Battery, Mains power
Software	Testo Saveris software