TESTO Saveris Series User Manual

6 Commissioning
42
3
Enter the IP address of the Saveris
base. This is located on the Saveris
base in the Info Base window.
4
Click on [Continue].
5
Click on [Units] to change the
temperature unit for the system.
6
Click on [MKT] (Mean Kinetic
Temperature) to simulate the effect of
temperature fluctuations over a
specific period of time.
1. Mark the channel.
2. Click [Add] to start the MKT
calculation for the selected
channel.
Several timestamps can be set for each channel.
7
Click on [OK].
8
Make any further changes to the existing system settings as required.

TESTO Saveris Series Specifications

General

Measurement Parameters	Temperature, Humidity, CO2, Pressure, Differential Pressure
Humidity Range	0 to 100 %RH
CO2 Range	0 to 5000 ppm
Communication	Ethernet, WiFi, USB
Data Storage	Internal memory
Alarm	Visual and audible alarms
Power Supply	Battery, Mains power
Software	Testo Saveris software