TESTO Saveris Series User Manual

7 Maintenance
89
2
Undo screws on the rear of the
Saveris data logger.
3
Remove housing cover of the Saveris data logger .
4
Change batteries .
Ensure that you insert the batteries correctly.
The correct polarity is illustrated in the respective battery compartment.
5
Place housing cover on the housing of the Saveris data logger.
6
Screw cover tightly onto the housing.
A control switch is located in the housing which is actuated through the
cover. To this end, the cover must be screwed to the housing of the
Saveris data logger without any gap.
If the control switch is not actuated through the cover, the Saveris data
logger cannot be operated.
CAUTION
Unwanted residual discharge when disposing of old batteries.
Mask the poles of the old batteries in order to prevent an unintended
residual discharge due to short-circuits during disposal.
Transport tip: If the Saveris data loggers are to be sent via air freight,
the batteries must be removed beforehand to avoid inadvertent radio
communication.

TESTO Saveris Series Specifications

General

Measurement Parameters	Temperature, Humidity, CO2, Pressure, Differential Pressure
Humidity Range	0 to 100 %RH
CO2 Range	0 to 5000 ppm
Communication	Ethernet, WiFi, USB
Data Storage	Internal memory
Alarm	Visual and audible alarms
Power Supply	Battery, Mains power
Software	Testo Saveris software