TESTO Saveris Series - Page 94

7 Maintenance
94
• You must acknowledge all outstanding alarms before a firmware system
update.
• ATTENTION: During the firmware update process, never disconnect the
power supply/network supply or the PC connection.
• During the update, measurements, data storage and data communication
are continued so there is no data loss.
• Configuration changes during the firmware system update should not be
carried out to ensure the process is not slowed down.
• Since there is heavy radio traffic during the update, alarms relating to
interrupted radio links may occur temporarily.
• Once a probe has been updated, the reboot phase takes approx. 1-2
minutes. During this brief time, no readings can be recorded.
Please note that the entire update process may take several hours.
During this time, no configuration changes or network/power supply
interruptions should occur.
1
Unpack the firmware file folder and save it to your PC.
2
Open the Saveris Start-up Wizard
and click on the System update
button in the Projects tab.

A Windows
®
Explorer Find folder window opens.
3
Select the destination directory where you saved the downloaded file
folder.
4
Confirm with [OK].

The process has been completed successfully message is
displayed after approx. 1 min.
5
Confirm with [OK].

The Saveris startup wizard closes automatically.

The firmware update for the Saveris base is installed.