Texas Instruments BQ28Z610-R2 User Manual

1 = Detected
0 = Not Detected
12.2.28 MACSubcmd() 0x0052 PFAlert
This command returns the PFAlert() flags on MACData().
Status Condition Action
Activate 0x0052 to MACSubcmd() Outputs PFAlert() flags on MACData()
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
RSVD RSVD RSVD RSVD RSVD RSVD RSVD RSVD RSVD RSVD RSVD RSVD RSVD RSVD
DFET
F
CFET
F
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
RSVD RSVD RSVD VIMA VIMR RSVD RSVD RSVD RSVD RSVD RSVD RSVD RSVD RSVD SOV RSVD
RSVD (Bits 31–18): Reserved
DFETF (Bit 17): Discharge FET Failure
1 = Detected
0 = Not Detected
CFETF (Bit 16): Charge FET Failure
1 = Detected
0 = Not Detected
RSVD (Bits 15–13): Reserved
VIMA (Bit 12): Voltage Imbalance While Pack Is Active Failure
1 = Detected
0 = Not Detected
VIMR (Bit 11): Voltage Imbalance While Pack Is At Rest Failure
1 = Detected
0 = Not Detected
RSVD (Bits 10–2): Reserved
SOV (Bit 1): Safety Cell Overvoltage Failure
1 = Detected
0 = Not Detected
RSVD (Bit 0): Reserved
12.2.29 MACSubcmd() 0x0053 PFStatus
This command returns the PFStatus() flags on MACData().
Status Condition Action
Activate 0x0053 to MACSubcmd() Outputs PFStatus() flags on MACData()
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
www.ti.com I2C Commands
SLUUCO0 – APRIL 2022
Submit Document Feedback
BQ28Z610-R2 81
Copyright © 2022 Texas Instruments Incorporated

Texas Instruments BQ28Z610-R2 Specifications

General

Brand	Texas Instruments
Model	BQ28Z610-R2
Category	Computer Hardware
Language	English