FAQs
In this section, you can find some of the most frequently asked questions about
UltraSync ONE, and our answers to these problems. If you have a question, you may
find that the answer is right here. If your question is not covered, please contact
Timecode Systems for assistance.
Can UltraSync ONE be used as a Master Unit?
Yes. UltraSync ONE is a timecode over RF transceiver, and so can be set as either a
master transmitting unit or a slave receiving unit in an RF network. It cannot be
used as a master in a BLINK network.
Can a Master Device use Drop-Frame Timecode?
Yes. The UltraSync ONE can use drop frame and standard frame rates.
How Long Does it Take for UltraSync ONE to Re-Sync?
If your UltraSync ONE moves out of range of the master, it will no longer be
synchronising with the master. It will re-synchronise with the master when it is back
in range of the master, but the amount of time the re-sync takes can vary:
UltraSync ONE Out of Range for Approx. Time to Resync
Less than 10 seconds Almost instantaneous
More than 10 seconds Several seconds
Note: If there are other masters in range, the re-synchronisation may
take considerably longer. This applies even if the other masters use
different RF channels.
UltraSync ONE User Guide 107
To Next Page
Loading...