timecode systems UltraSync ONE - Getting Started - EXT LTC Input

Getting Started - EXT LTC Input
Your UltraSync ONE can receive timecode, FPS, and user bits data from an external
device and then pass this on to other devices. To work in this way, your UltraSync
ONE needs to run in EXT LTC Input mode.
There are two different ways of using EXT LTC Input mode. You can set your
UltraSync ONE to:
l Receive timecode via the LTC port and then transmit timecode to slaves via
radio. Follow the steps in Set UltraSync ONE to use LTC as an Input on page
56.
l Receive timecode via the LTC port and then transmit timecode via a wired
connection. Follow the steps in Set UltraSync ONE to use LTC as an Input on
page 56 and Send Timecode from a Standalone UltraSync ONE on page 59.
46 UltraSync ONE User Guide