Set the Timecode for the Master
Note: This section only applies if you have set your UltraSync ONE to run
in Master TX mode (see Quick Set Up: UltraSync ONE as Master TX on page
1).
If your UltraSync ONE is set to run in Master TX mode, it means it is the master in an
RF network. As it is the master, you need to set its timecode. The timecode will
then be transmitted to the slaves in the network, so that they can synchronise with
the master.
To set your UltraSync ONE's timecode:
1. Make sure your UltraSync ONE is switched on (see Switch UltraSync ONE On
and Off on page 11).
2. Press the Select button.
3. Use the Up and Down buttons to scroll to the TC Generator option.
4. Press the Select button.
5. Use the Up, Down, and Select buttons to set the UltraSync ONE's time. Press
Up or Down to change the value of a character, and then press Select to
confirm that value and move to the next character (from left to right). When
you have set the last value, pressing Select will confirm the time entry.
You also need to Set the Frame Rate Per Second (see page 73).
72 UltraSync ONE User Guide
To Next Page
Loading...