Set the RF Channel
If you are going to use your UltraSync ONE in an RF network, you need to set its RF
channel to match the other Timecode Systems devices in the network. (An RF
network is a group of Timecode Systems products that all use the same RF channel
for radio communications).
You need to set the RF Channel when:
l You first set up your UltraSync ONE to join an RF network
l You want to move your UltraSync ONE from one RF network to another
l You are changing the master device in the RF network. Your UltraSync ONE
needs to have its RF Channel reset if you introduce a different master device,
even if the same channel is going to be used.
Note: UltraSync ONEs can only be part of one RF network. To move an
UltraSync ONE between networks, change the UltraSync ONE's RF
Channel, and then restart the unit.
To set your UltraSync ONE to join an RF network:
1. Make sure your UltraSync ONE is switched on (see Switch UltraSync ONE On
and Off on page 11).
2. Press the Select button.
3. Use the Up and Down buttons to scroll to the Set RF Channel No. option.
4. Press the Select button.
5. Use the Up and Down buttons to set the UltraSync ONE to the same channel
number as the other devices in the RF network.
6. Press the Select button to confirm.
68 UltraSync ONE User Guide
To Next Page
Loading...