Master to RF Slaves and Wired Devices
You can set your UltraSync ONE up so that it provides timecode to a device that is
wired to the UltraSync ONE, and also to RF slaves. To act as the master and the
timecode source, the UltraSync ONE has to be set to run in Master TX mode.
Note: If you want your UltraSync ONE to receive timecode from an
external device, and then pass that timecode on to RF slave devices, see
Set UltraSync ONE to use LTC as an Input on page 56.
UltraSync ONE User Guide 47
To Next Page
Loading...