Set the Frame Rate Per Second
Note: This section only applies if your UltraSync ONE is running in Master
TX mode or is free running in Free Run/Jam-Ext mode. If your UltraSync
ONE is running in Ext LTC Int or RF Slave mode, it will receive the FPS
data from the master or external timecode source.
The FPS (Frames-Per-Second) of your UltraSync ONE has to match the FPS of the
cameras and sound mixers/recorders that are being used on the shoot. This is
because timecode can only be applied accurately to each recorded frame if the
same FPS settings are used.
To set the FPS:
1. Make sure your UltraSync ONE is switched on (see Switch UltraSync ONE On
and Off on page 11).
2. Press the Select button.
3. Use the Up and Down buttons to scroll to the TC Generator option.
4. Press the Select button.
5. Use the Up and Down buttons to scroll to the Set FPS Rate option.
6. Press the Select button.
7. Use the Up and Down buttons to set the UltraSync ONE's FPS to the
appropriate value.
8. Press the Select button to confirm.
You also need to Set the Timecode for the Master (see page 72).
Note: If your UltraSync ONE is running in Master TX mode, it will send the
FPS to the slave units in the RF network, so that they also use the same
FPS.
UltraSync ONE User Guide 73
To Next Page
Loading...