If you know how to access your UltraSync ONE's settings and understand
the different modes, you can use the quick set up instructions to get
started.
Preparation - Before you Set Up your UltraSync ONE 44
Master to RF Slaves and Wired Devices 47
Master to Wired Device Only, No RF Slaves 50
Run UltraSync ONE as an RF Slave 52
How does an RF Slave Synchronise with a Master? 54
Set UltraSync ONE to use LTC as an Input 56
Send Timecode from a Standalone UltraSync ONE 59
Jam UltraSync ONE to a Signal 61
UltraSync ONE User Guide 43
Quick Set Up
Chapter 3 Quick Set Up
To Next Page
Loading...