8. Press the Select button.
9. Use the Up and Down buttons to choose the output signal that is appropriate
for your device. The manufacturer's instructions for your device should
provide details on the type of genlock or word clock signal that is supported,
and also its level.
Note: Most cameras use 1080p genlock, but Sony cameras use 1080p
PSF.
10.
Note: You can disable SYNC output by setting the Sync O/P Mode to
Off.
11. Press the Select button to confirm.
12. Press the Select button.
13. Use the Up and Down buttons to scroll to the Sync Generator option.
14. Press the Select button.
15. Use the Up and Down buttons to scroll to the Set Sync O/P Level option.
16. Press the Select button.
17. Use the Up and Down buttons to scroll to the appropriate level for your
device. We recommend that you use Std. O/P Level first, and if there is no
connection between your device and the UltraSync ONE, try changing the
level to High.
l Std.O/P Level
l High O/P Level
Note: If you are using the SYNC port to output genlock, the Std. O/P
Level is a 170mVpp signal and the High O/P Level is a 2.7Vpp signal.
18. Press the Select button to confirm.
Your UltraSync ONE will now output a genlock, word clock, or timecode signal to
your device via the SYNC port.
UltraSync ONE User Guide 77
To Next Page
Loading...