1-3
■
- When you use an arm, please verify that screws are firmly fastened before use.
The probe attached to the arm may be fallen and damaged, or fallen to a
patient's eyeball or eyelid and injury them.
If you move an arm by holding it directly, you may be injured with hands or
fingers caught
.
- Do not allow water or chemicals to splash on probes, except for the tip caps
and the purified water inlet
.
Any water or chemicals entering the instrument
may cause an electric shock or failure.
- Do not allow the patient to touch the terminals for connecting the instrument to
external devices.
- Since simultaneous use of multiple devices can cause misdiagnosis or result
in a hazardous situation, exercise caution when using this instrument.
- Check the sections that the patient will directly touch.
- Check that the instrument is correctly grounded.
- Check that the date set in the instrument conforms to the actual operation date
and time.
■
Precautions during operation
- Do not place any container with liquid in it on the instrument. Any liquid
entering the instrument may cause electric shock or failure.
- Do not allow the patient to touch the terminals for connecting the instrument to
external devices.
- Be sure to touch the “New” button on the main unit to delete the measurement
data for the previous patient before measuring a new patient. If new
measurement is started without deleting the previous data, the measurement
data for the previous patient may be included.
- Do not lean on the instrument or press the instrument from the top. The
instrument may topple over, resulting in mechanical failure or injuries.
- Do not allow water or chemicals to splash on probes, except for the tip caps
and the purified water inlet
.
Any water or chemicals entering the instrument
may cause an electric shock or failure.
To Next Page
Loading...
Need help?
General
