■
3-158
3) When a desired box on the measurement point change screen (Fig. 2) is
touched, the box is activated. Set values using the keypad and the like. As
for the setting of “S/I,” the indication switches between “S” and “I” each time
the display button (4) is touched.
4) Touch the Preset button (5) to set the value preset in utility. (Refer to
“3.12.2 p) Cornea Thickness Setting.”)
5) Touching the “Setting” button (6) will reflect the changes made, and the
measurement point change screen (Fig. 2) is closed. Touching the “Cancel”
button (7) will cancel the changes made, and the measurement point
change screen (Fig. 2) is closed.
3-116
(Fig. 2)
(4)
(5)
(6)
(7)
To Next Page
Loading...
