■
3-216
(7) “Cancel” button
Cancels the entered data and returns to the top page of the Tomey Link Setup.
■ When only this instrument and the Tomey Link Server
or a computer running Data Transfer are connected in
the network, the following settings can be used.
1) Check the computer IP address.
Check and record the IP address and subnet mask of the computer with DATA
Transfer installed. Refer to the DATA Transfer operation manual for details.
2) Set settings on the Instrument.
The settings shown in the table below describe an example when the IP
address of the computer with DATA Transfer installed is “192.168.2.128” and
the subnet mask is “255.255.255.0.” The IP setting method in this case is
“Manual.”
Computer settings Instrument settings
192 168 2 128 192 168 2 129
(Local)
IP address
Check these on the DATA
Transfer screen.
Same value as
computer setting
(＊1)
255 255 255 0 255 255 255 0 Subnet
mask
Check these on the DATA
Transfer screen.
Same value as computer
setting
0 0 0 0 Default
gateway
-------
All “0”
192 168 2 128 Host IP
address
-------
IP address of computer
*1: An arbitrary number from 1 to 255 excluding numbers used by the computer
(128 in this example)
Setting examples
To Next Page
Loading...
